What transmission fluid goes in a 4l80e?

Manufacturer Transmission Type Transmission Fluid
CHEVROLET 4L80E DEXRON VI
ISUZU 4L80E DEXRON III
JAGUAR 4L80E DEXRON III
ROLLS ROYCE 4L80E DEXRON III

Is dexron 3 the same as ATF 4?

Dexron IV was an upgraded version of Dexron III, which was used by GM only briefly. … GM considers Dexron VI to be “backward compatible,” meaning GM recommends it for use in any vehicle that originally used any earlier version of Dexron and that it can be mixed with them.

What does the E stand for in 4L80E?

The 4L80E transmission was mostly used in 34- and 1-ton trucks and larger SUV applications beginning in 1991. The “E” means that it must use an electronic ECU for control, as it will not function without it.

How much HP can a 4L80E handle?

How much power can the 4L80E handle? A totally stock unit or rebuild will typically live well with up to 450 flywheel HP/TQ.

How many quarts of transmission fluid do I need?

In general, transmissions take about 9 to 13 quarts to fill completely. The amount of transmission you add will vary, depending on whether you are draining or replacing it all or you are just topping it up. Again, you should avoid adding too much. It is advisable to put in little amounts at a time.

IT IS INTERESTING:  When did Bobcat stop using Kubota engines?

What can I use in place of Type F transmission fluid?

This type of drive train fluid should not be used in automatics that require Type F. It can be replaced with Mercon or Mercon V specification.

Can you mix Type F transmission fluid?

As to ATF, no problem mixing Dexron and Type F, one can actually fine tune shift harshness as Type F is in fact “grippier”.

What is the difference between Type F and Dexron transmission fluid?

What is the difference between DEXRON® III/MERCON® and type F transmission fluid? The Valvoline Type F transmission fluid is a high quality NON-friction modified fluid. DEXRON® III/MERCON includes friction modifiers in the fluid additive package.

What transmission fluid is compatible with ATF 4?

ATF+4 is fully compatible with all transmission applications where ATF+, ATF+2 and ATF+3 Automatic Transmission Fluids are specified. Only certified ATF+4 is recommended for service of FCA vehicles as where ATF+4 is specified in the owner’s manual.

What happens if you use the wrong automatic transmission fluid?

Automatic transmissions must only use the fluid specified by the automaker, such as General Motors’ Dexron series or Toyota’s Type T. Using the wrong fluid can cause poor lubrication, overheating, and possibly transmission failure. A mechanic might not be able to reverse the damage, even by flushing the transmission.

Is dexron 3 and mercon the same?

Dexron III and Mercon V are similar types of automatic transmission fluid, with the main difference being that Dexron is the formula developed by General Motors, while Mercon was created by Ford. … However, Mercon LV and Mercon V are not compatible, so any Ford vehicle manufactured before 2008 requires Mercon V.

IT IS INTERESTING:  Are 4 stroke engines quieter?
Blog about car repair