We are going to look at the replacement process for you. You will pay between $230 and $310 for a windshield wiper motor replacement. The cost of labor on this job will be between $50 and $70, while the cost of parts should be between $180 and $250.
How much does it cost to replace a rear wiper motor?
The Best in Auto Repair
The average cost for windshield wiper motor replacement is between $300 and $354. Labor costs are estimated between $79 and $99 while parts are priced between $222 and $254. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location.
How do you fix a rear wiper motor?
Remove rear wiper motor as follows: Detach the connector. Remove the 3 bolts and rear wiper motor assy.
How do you fix a rear windshield wiper motor?
- Step 1 – Disconnect the Cable to the Car Battery.
- Step 2 – Remove the Wiper Assembly.
- Step 3 – Remove the Wiper Motor.
- Step 4 – Install the New Motor.
How do you test a rear wiper motor?
Check for voltage input to the rear wiper relay by removing the relay from the panel and measuring voltage at the appropriate socket terminals with the ignition on. If there is voltage input to the relay but no voltage reaching the motor, then the relay is faulty and should be replaced.
How long should a wiper motor last?
The wiper motor on a car is supposed to last a lifetime. Typically, this will not be the case due to the conditions that this part of a car is exposed to. The heat and moisture that a wiper motor is exposed to on a daily basis will eventually lead to you having to get it replaced.
How do you test a wiper motor?
Use the fuse pattern shown on the cover and locate the wiper motor fuse. Test the fuse using your twelve volt test light. Clip the ground lead to a solid ground source and touch the positive lead to each side of the fuse. If the test light lights up on both terminals, the fuse is good.
What makes windshield wipers stop working?
When a windshield wiper is not working, it could mean that the electrical motor inside the wiper shorted out or malfunctioned. This means that your wipers won’t work at all. Inspect the motor – there could be a loose wire in the circuit.
What happens when a wiper relay goes bad?
When the relay is faulty, the windshield wipers will only work at the same speed that the last relay signal was sent. … If you make a change in the settings and the wipers don’t react, it’s most likely due to a malfunction in the intermittent wiper relay.
How do you fix a noisy wiper motor?
Turn on the windshield wipers and spray WD-40 on the wiper arm to pivot arm connection. Make sure you also lubricate the joint that connects the pivot arm to the wiper motor with WD-40. If the squeaking does not go away, then you will want to replace the motor. Turn off the windshield wipers.