Frequent question: How long does it take to fix a transmission control module?

The cost of TCM replacement depends on the make and model of your vehicle, plus the cost of parts and labor. It’s also important to factor in the amount of time it could take to replace the module because some imported parts can take 2 to 4 weeks to arrive.

Can you drive with a bad transmission control module?

Problems with your transmission control module can result in not being able to shift properly which can cause accidents and injury. On top of that, driving with a faulty transmission control module can cause lasting damage to the wiring in your transmission.

How much does it cost to repair a TCM?

The replacement cost of a transmission control module will be anywhere from $500 to $900. You can expect the parts costs to be around $450 to $700 while the labor costs will be around $50 to $200. Of course, you can order a new TCM online and ask a mechanic what their hourly labor rates are.

How much does it cost to fix a transmission module?

The average cost for transmission control module replacement is between $716 and $779. Labor costs are estimated between $101 and $128 while parts are priced between $614 and $651. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location.

IT IS INTERESTING:  What is a transmission fluid sensor?

How do you reset transmission control Module?

Steps to Resetting Transmission Control Module

  1. Step 1: Turning Key Position. Before resetting the transmission control module, it is necessary to check the key position. …
  2. Step 2: Press gas pedal. …
  3. Step 3: Keep Waiting. …
  4. Step 4: Turning the Key Off. …
  5. Step 5: Releasing Gas Pedal. …
  6. Step 6: Wait Again. …
  7. Step 7: Ready.

How do you check a transmission control module?

The transmission control module can often be found below the cover at the back of the transmission and should be located just near the engine control module’s position. The position of the transmission control module is found under the center console in the interior or under the hood near the car battery.

What makes a TCM go bad?

Damage to the control module can be caused by voltage overload, when there is a short in the solenoid or actuator circuit; when water causes the circuits to get shorted out; or vibration and thermal stress.

Does a TCM need to be programmed?

When you install a new TCM in these vehicles, it must be programmed with dealer-level equipment or equivalent, and the programming must be performed on the vehicle. What’s more, you should never try to drive the vehicle to the dealership after the repair; it may cause premature transmission failure.

Does a transmission control module have to be programmed?

Short answer is NO. No programing is required if the new TCM came out of a working car of the same elk as yours.

What are the signs of a bad transmission control module?

Some common signs of a bad transmission control module include:

  • Unpredictable shifting.
  • Trouble shifting into higher gear.
  • Trouble downshifting.
  • Getting stuck in the same gear.
  • Poor fuel economy.
  • Check engine light comes on.
IT IS INTERESTING:  How do you increase the power of an electric motor?

What are the symptoms of a bad transmission control solenoid?

If you’re experiencing transmission solenoid troubles, it will become evident in one of four ways:

  • Delayed gear shifting.
  • You can’t downshift, and your engine continues to rev even when applying the brakes.
  • Your transmission gets stuck in neutral.
  • Shifting gears become rough and choppy.

Where is the transmission control switch located?

The Transmission Control Switch (TCS) is a momentary contact switch that is located on the end of the transmission control selector lever. Pushing the TCS will either disengage or engage the overdrive function of the transmission.

Blog about car repair