Does a blower motor resistor have a fuse?

A fuse is often located on the resistor board. The fuse only protects the low and medium blower speeds. High speed will still work if the resistor fuse is blown.

Is there a fuse for the blower motor?

The blower motor is powered by a fuse-like device called a relay. If your heater or air conditioner does not blow air through the vents, this could indicate that the blower motor fuse has probably blown. While replacement is easy, the exact location of your blower motor fuse may vary from vehicle to vehicle.

Will a blower motor work without the resistor?

If the resistor shorts or fails, it may cause the blower motor to remain stuck on one fan speed. The heating and air conditioning systems may still function at one speed, however the resistor will have to be replaced in order for full functionality to be restored.

How can you tell if a blower fuse is blown?

Look at the fuse wire. If there is a visible gap in the wire or a dark or metallic smear inside the glass then the fuse is blown and needs to be replaced.

IT IS INTERESTING:  Is glass covered in car insurance?

How do you check a blower motor fuse?

Use voltmeter or ohmmeter to check for a blown fuse. If you find one, replace it. Start car and see if blower motor works. If fuse blows again, check for loose circuits.

What can cause a blower motor to stop working?

In a situation where the motor doesn’t work on any speed, the most likely causes are: a blown power supply fuse, a bad motor ground connection, bad motor speed control module or a failed motor. On all systems, a failed blower motor is least likely. … Start by checking the blower fuse and HVAC controller fuse.

Can I bypass blower resistor?

In the highest speed state, the blower resistor is bypassed completely and the fan is connected directly to the car’s battery, which allows maximum current through the motor. Power to the blower motor is fed through the blower motor resistor, so if it fails or has any issues power can be cut off to the motor.

How much does it cost to replace a blower motor resistor?

The average cost for blower motor resistor replacement is between $108 and $137. Labor costs are estimated between $44 and $55 while parts are priced between $64 and $82. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.

What happens if your blower motor relay is bad?

If the blower motor relay develops any sort of problem that hinders its ability to properly limit and distribute power, it may cause the blower motor fuse to blow. Any sort of electrical spikes or excessive current from a bad relay will blow the fuse and cut power in order to protect the system.

IT IS INTERESTING:  How can you tell if your transmission is overheating?

Why did my fan stopped working?

Whether the blades aren’t spinning or the fan is making tons of noise, most issues with an electric fan are caused by poor lubrication or blockages in the vents. To solve most problems with an electric fan, disassemble the fan, lubricate the central pin and bearings, and clean out the vent and motor case.

Can a blower motor be repaired?

Blower Motor Replacement: When Good Parts Go Bad. … There are a number of things that can go wrong with your heating system, but if the air stops blowing altogether and the same is true on cold air settings, a blower motor replacement is likely in order. The good news is that it’s a fairly straight forward repair.

Blog about car repair