They’re generally easy to find — they’re connected at the back to the top of your child’s convertible, multimode, or combination car seat. There are two parts to top tether togetherness. The top tether anchor on the car seat and the tether anchor on the vehicle itself.
What can you do if your car doesn’t have a tether?
If your car doesn’t have top tethers anchors — some older models don’t — your car dealer can retrofit them for any car dating back to 1989. Just step into a dealership; they can do it for you or provide you with an anchor kit.
Can you add a tether to a car?
Tether anchors can be added to many vehicles manufactured between 1989-1999. Many of these vehicles have the holes pre-drilled in the vehicle, often with the nut in place, so that retrofitting the tether anchor is as simple as ordering the part and screwing in a bolt.
Do all car seats need to be tethered?
Some car seats and vehicles allow a seat to be tethered rear facing. In Europe this is far more common, in Australia it’s required, but in the United States very few car seat manufacturers permit tethering rear facing. Canada has said that rear facing tethering is not permitted at all.
Can I install car seat without tether?
Older Vehicles may not Accommodate Forward Facing Car Seats
In a car without tether anchors, the Graco Extend2Fit lets this 4 year old continue to safely rear face. … Rear facing car seats fit just fine in many vehicles that don’t include factory-installed tether anchors becuase they don’t require a top tether.
Does my car have top tether?
In most cars the top tether point is located on the back of the vehicle seat. Sometimes you can find it lower down at the base of the backrest, and in some cars it’s on the floor of the boot.
What is a top tether?
A top tether is a fabric strap that secures the child seat to a tether point behind the rear car seat, usually at the back of the rear seat, the bottom of the trunk or on the ceiling. Check your car’s handbook for the exact location in your car.
Do booster seats need a top tether?
If the booster seat comes with a tether strap, it must be anchored to the child restraint anchorage point. However some booster seats that meet the Australian Standard (AS/NZS 1754) do not come with a tether strap and therefore do not need to be anchored in the vehicle.
When should I stop using LATCH?
In order to use the LATCH system, the sum of the child’s weight and the weight of the car seat must be no more than 65 pounds. Since most car seats weigh upwards of 20 pounds now, many manufacturers recommend that you stop using the LATCH system when a child reaches 40 pounds.