Even if the hose is hot oil rated it still might not be recommended for fuels. The hoses inner most tube must have the rating for fuels for maximum use.
Can I use transmission hose for fuel line?
Yes, you can install cheap fuel hose, and it WILL work but the question is, ‘for how long?’ . Transmission cooler hose is noticeably thicker and stiffer, and you can safely assume that the type of rubber used will work long-term with atf.
Does a fuel hose have to be a special hose?
With in-tank (submersible) applications, fuel also comes in constant contact with the outside hose cover, making it vital to use a hose that’s engineered to be submersible. For in-tank applications, fuel line must meet or exceed the SAE 30R10 rating, which is the standard for submersible fuel line hose applications.
Can you repair transmission line with rubber hose?
You can use rubber hose, but make sure it’s transmission cooler line rated. The pressure is quite low (12-15 psi). Double clamp it or use FI type clamps instead of the worm-drive style.
Are transmission cooler lines under pressure?
there is at idle between 20-50 psi but during use pressures in transmission lines can reach 100 psi or more. if you are going to use rubber lines be sure to use barbed fittings so the hose does not blow off. Cooler and lube pressure are about the same at 5-30 psi.
What size fuel hose do I need?
Recommended Size, Based on Horsepower
|Recommended Fuel Line Size (from the tank to the pump)|
|Engine Output||Size (inches)||Size (AN)|
|350 hp or less||5/16 in.||-5|
|350-450 hp||3/8 in.||-6|
|450-650 hp||1/2 in.||-8|
How do I know if my fuel line is hose?
Tubing is OD (outside diameter) and Pipe is ID (inside diameter). So the easiest way to tell the size of your fuel line, which is tubing, is to use a combination wrench. Whichever one slips over snuggly is the winner.
Is all fuel hose the same?
When you’re looking for a fuel line hose, what you’re planning to use it in makes all the difference. A lawn mower fuel line hose and a fuel injection hose may look the same, but they are worlds apart. A fuel injected engine runs at a much higher fuel pressure than a carbureted one does.
How much does it cost to replace transmission fluid hose?
Once those lines start to malfunction, then the transmission fluid can overheat. You will pay somewhere between $100 and $450 for a transmission cooler line replacement. The labor should be between $60 and $300, while parts can cost you anywhere from $40-$160.
Do transmission lines run through the radiator?
Car transmission lines connect your vehicle’s transmission to the vehicle’s radiator. … Your car’s transmission lines are essential to preventing the transmission from overheating by carrying hot fluid away from the transmission until it is cooled and subsequently pumped back into the transmission.